5-Axis Machining Center with 45° Tilt Head
- Material: Aluminum alloy
- Size: Ø274 × 109 mm
- Machining Cycle: 706 minutes
- Material: Aluminum alloy
- Size: Ø740 × 510 mm
| Model | | | | |
| Worktable size (mm) | Ø800 /800×800 | Ø1000 /1000×1000 | Ø1250 /1250×1250 | Ø1600/Ø1800/Ø2000 |
| Max. worktable load capacity (kg) | 2000 | 2000 | 2000 | 2000 |
| X-axis travel (mm) | 1200/1400 | 1600 | 1600 | 2100 |
| Y-axis travel (mm) | 1000/1200/1400 | 1000/1200/1400 | 1000/1200/1400 | 1250/1600 |
| Z-axis travel (mm) | 1100/1400 | 1600 | 1600 | 2100 |
| B-axis swing range (°) | n×360 | n×360 | n×360 | n×360 |
| C-axis rotation range (°) | -15 to 195 | -15 to 195 | -15 to 195 | -70 to 180 |
| Spindle speed (r/min) | 20–15000 | 20–15000 | 20–15000 | 20–10000 |
| Positioning accuracy (X/Y/Z) (mm) | 0.008 | 0.008 | 0.008 | 0.008 |
| Repeatability (X/Y/Z) (mm) | 0.004 | 0.004 | 0.004 | 0.004 |
| B-axis positioning accuracy (″) | 8 | 8 | 8 | 8 |
| B-axis repeat positioning accuracy (″) | 4 | 4 | 4 | 4 |
| C-axis positioning accuracy (″) | 10 | 10 | 10 | 10 |
| C-axis repeat positioning accuracy (″) | 5 | 5 | 5 | 5 |
The spindle assembly uses a 45° tilting head that switches between vertical and horizontal machining, with the spindle mounted on this tilting axis to rotate along the C-axis for angled operations. The spindle uses a built-in motor, so the drive power goes directly into the spindle and stays steady during cutting. The bearing temperature is tracked so the spindle stays steady and the machining accuracy doesn’t drift during long cuts.
The X, Y and Z axes use servo-driven linear guide rails paired with precision ball screws. The axes can move at high speed, up to 40 m/min, while still keeping positioning steady, and the low-speed motion stays smooth without any crawling. The linear guides use a centralized lubrication system that keeps friction down and reduces wear, which helps the machine hold its accuracy over long periods of use.
What should be kept in mind during routine maintenance on a 45° tilt-head 5-axis horizontal machining center?
It’s important to check not only the 45° tilt head, but also the spindle assembly, the linear-axis guideways and ball screws, the servo motors and drive system, and the tool magazine and tool-change mechanism. These areas just need good lubrication, proper cooling and small routine checks so their movement stays smooth and the accuracy doesn’t start drifting.