Rebar Coupler
Request a Quote
The rebar coupler is designed for joining rebars with a full tension capacity. It is suitable for the rebars in a variety of diameters ranging from Φ12 to Φ50mm. The connected bar ends can be in contact or parallel to each other. We can customize five series of rebars according to your requirements, including standard type, positive and negative turnbuckle type, different diameter type, wide mouth type, and nut locking type. These rebar couplers are widely used in architectural engineering, tunnels, bridges and more.
1. Standard type:
It is used under normal circumstances.
It is used under normal circumstances.
2. Positive and negative turnbuckle type:
It is used when both rebar ends can’t rotate.
It is used when both rebar ends can’t rotate.
3. Different diameter type:
It is used when the diameters of two rebar ends are different.
It is used when the diameters of two rebar ends are different.
4. Wide mouth type:
It is used when the rebar end are difficult to be center.
It is used when the rebar end are difficult to be center.
5. Nut locking type:
It is used when the required rebar can’t rotate. It joins the rebar by rotating the rebar coupler first, then locking the coupler and rebar using a nut.
It is used when the required rebar can’t rotate. It joins the rebar by rotating the rebar coupler first, then locking the coupler and rebar using a nut.
Production Process of Rebar Coupler
- Cutting rebar
- Bore
- Rough lathing the bottom hole
- Strip the ex-circle
- Finish turning the bottom hole
- Countersirk
- Rust-proof treatment
- Test and pack
Related products
Send Message
Other Products
Most Recent
More
Other Products
Videos