ADS Series Hall-Effect Rotary Angle Displacement Sensor with Hollow Shaft Manufacturer

ADS Series Hall-Effect Rotary Angle Displacement Sensor with Hollow Shaft

Request a Quote

View All: http://solution-sensor.com/9-1-ads-series-hall-effect-rotary-angle-displacement.html

Yuanben ADS series rotary angle displacement sensors may potentially be mounted adjacent to the pedal to measure how far the pedal is depressed or released by the operator. The sensor senses the change in pedal position and sends a signal to the engine control unit to either increase or reduce the flow of gasoline and air across the throttle plate, as needed.

Yuanben provides non-contact operation, low torque actuation and reduces worn-out mechanisms. Wider sensing range and multi factory-set operating ranges (60°, 90°, 120°, 180°, 270°, 360°) allow the customer to select the range of travel needed for the application, and used in harsh transportation and industrial applications at a competitive cost.

Features

True, non-contact operation
Solid-state Hall-effect technology
Rugged IP69K-sealed package with integral connector
Automotive-grade EMI/EMC testing, integrated reverse polarity, and short circuit protection
Industry-standard AMP termination, North American or European pin-out styles, and compact seal
Operating ranges up to 360°

Applications

Transportation

Position and movement detection of pedals, throttles, gear shift, levers, steering, linkages, and hitches (trucks, buses, off-road vehicles, cranes, and industrial/construction/agricultural vehicles and equipment)
Suspension/kneeling position (buses, trucks)
Tilt/trim position (boat engines, tilling equipment)

Industrial

Valve control
HVAC damper control
Irrigation equipment pivot control

Technical Parameters

Type		ADS Series (Low Voltage)	ADS Series (High Voltage)
Supply Voltage		5 ±0.5 VDC	10VDC to 30VDC
Supply Current	Normal	20 mA max	20 mA max.
	During output to ground short	25 mA max	25 mA max.
Output	Standard	0.5 VDC to 4.5 VDC ratio-metric	0.5 VDC to 4.5 VDC ratio-metric
	Inverted	4.5 VDC to 0.5VDC ratio-metric	4.5 VDC to 0.5 VDC ratio-metric
Output Signal Delay		4 ms typical	4 ms typical.
Reverse Polarity Protection		10 VDC	-10 VDC
Over-voltage Protection		10 VDC	10VDC
Output to Ground Short Circuit		Continuous	Continuous
Resolution		12 bit	12 bit
Output Load Resistance (pull down to ground)		10 kOhm typical
EMI	Radiated immunity	100 V/m per IS011452-2 from 200 MHz to 1000 MHz
	Conducted immunity	100 mA BCI per ISO11452-4 from 1 MHz to 200 MHz
Expected Life		Infinite rotation
Air Gap	Bare magnet actuator	3 mm ±0.5 mm [0.12 in ±0.02 in]
	Housed magnet actuator	2 mm ±0.5 mm [0.08 in±0.02 in]
Misalignment		2 mm [0.08 in]max.
Material	Magnet	NdFeB
	Sensor housing	PBT plastic
	Housed magnet overmold	PPS plastic
	Housed magnet	Brass
Mating Connector		AMP Super-seal 282087-1
Mechanical End Stop		No