TDSJ-B1 concrete wire sawing is especially suitable for cutting extremely thick and heavily reinforced concrete or irregular and complex concrete such as bridge's cap beam, box beam, support beam, high speed rail bridge pier, equipment foundations, underwater concrete cutting and so on. Additionally, it is not restricted with cutting depth and has higher working efficiency and is also more applicable for all kinds of environment compared with hydraulic wall sawing machine. Therefore, wire sawing can be provided as a supplemental equipment of hydraulic wall cutting machine, which is widely used in demolition company. In the construction project of demolition company, hydraulic wire sawing is a kind of advanced engineering tools applied to building engineering modification and reinforcement construction.

1. The type of concrete wire sawing is composed of 9 wheels.
2. The wire storage capacity is up to 11.2m.
3. Machine dimension is 650*815*1760(L*W*H).
4. Singe motor is adopted to drive guide wheel collect wire.
5. Single gate protection cover and water spraying function is also equipped on our wire sawing.
6. The materials of machine adopt aluminum magnesium alloy.

1. All guide wheels are made from aluminum magnesium materials, which is much lighter than iron. The structure of guide wheel adopt up and down fastening featured as simple and good sealing and waterproof performance. The bearing of wire sawing adopts high speed double raw angular contact ball bearing, which increases the width of bearing to enlarge area of thrust surface ensuring more stable and safe operation with higher service life.

2. Machine walking plate is installed with disassemble wrench for the convenience for dismounting, which can adjust eccentric shaft to press tracks and ensure compact connection between plate and tracks. Wire guiding device can move flexibly to adjust cutting angle and also can prevent falling off of wire when stop the machine.

3. The walking type of plat adopts double gear engagement ensuring cutting precision. The shaft of several guide wheels adopts square head connection, which has the advantage of easy dismounting and securing connection. Horizontal bar, driving wheel and track are all clamped with four anchor ears structure and four bolts, which is more secure.

4. The rear end of driving guide wheel is installed with bearing and support frame leading to more stable operation. In the series of guide wheels, this type has smallest size and lightest weight, which can be applied to cut all kinds of serve conditions. The middle of horizontal bar is equipped with adjustable wheels and you can change wire collecting place by adjust bolt place and increase wire storage capacity.

TD hydraulic power station: 1 piece
Oil pipe: 5 pieces
Water pipe: 1 piece
Clamping piece: 2 pieces
Waterproof plug: 2 pieces
Single structure: 1 piece
Wire collecting: 1 set, including of one walking and driving large flywheels and two small flywheels and saw tracks

The installation of wire sawing is very simple. The concrete diamond wire sawing system can be dismounted for three parts. The installation and fixation of the machine can be finished on the conditions of only one worker.
1. Just install rail feet and rail
2. Install driving wheel additionally.
3. Install wire colleting guide wheels