Dual Lane PCB Workstation Belt Conveyor
Material Handling Equipment, Transfer and Conveyor Solutions, Work Table Conveyor
Brief Introduction
In this dual lane PCB workstation belt conveyor, two main configurations are 1HP Toho horizontal gear motor and a 350 mm wide work table. The table is produced using δ18mm wood plates and covered with anti-static rubber.
Attractive Features
Drive system
1. Both ends are manufactured from square steel. It's of high stability and fastens the motor.
2. The speed regulator realizes a processing speed of 0-6 meters per minute, with little noise.
Machine Design
1. The support makes use of 40mm×40mm square steel and the work stable is 750±20mm.
2. Each part of this material handling equipment is connected by standard screws, which is easy to disassemble, stable and hard to deform. Plus, the disassembly does no harm to the screw.
3. The beams are produced from 40×60 mm aluminum square tubes, with no harm to the electronic products.
4. The conveyor belt is imported from Netherland, allowing for seamless connection and anti-static capacity.
5. In order for smooth material transfer, galvanized plates are used below the conveyor belt and rollers are installed every meter in the conveyor.
6. In the power supply system, galvanized trunking and 4mm2 power line are used. Additionally, multiple outlet is mounted every meter in the system.
7. Above the lamp bracket, two aluminum beams are installed with gliders.
8. T5 18W LED lights are installed on both sides for lighting.
