Angle Roll, W24S-500
To bend large size profiles into round, arch and spiral shapes, our W24S-500 angle roll will be your preferred solution. This steel bending machine achieves up to 500cm3 bending modulus and delivers extreme versatility for bending large L, U and H steels, flat steels, round pipes, square pipes and other profiles.
Features of the Angle Roll
1. All three rolls of the heavy duty metal bending machine are individually driven, avoiding profile slipping during bending.
2. All motions and actions are powered by the hydraulic system and controlled by a centralized electric control system.
3. All motors are wideband, ensuring high insulation performance and long service life.
4. Bending dies are forged from 42CrMo steel and go through surface hardening treatment. As a result, the surface hardness reaches HRC45-55.
5. In addition, the bending dies can be customized according to the specifications of profile to be bent.
6. The hydraulic angle roll is equipped with displacement sensor for higher precision in digital display of lower roll's position (±0.15mm accuracy).
7. Two lower rolls or side rolls can move around the central shaft to realize pre-bending of profiles, leaving short straight section and thereby saving materials.
8. As a professional profile bender exporter, Juli can appoint technicians to guide on-site installation and provide operators training service.
| Model | W24S-500 | ||
| Max. bending modulus of section (cm3) | 500 | ||
| Bending speed(m/min) | 3.5 | ||
| Yield limit of material ( MPa ) | 245 | ||
| Inward bending of angle steel | Maximum cross section (mm) | 250×25 | |
| Minimum bending diameter (mm) | 4000 | ||
| Minimum cross section (mm) | 85×6 | ||
| Minimum bending diameter (mm) | 1600 | ||
| Outward bending of angle steel | Maximum cross section (mm) | 250×25 | |
| Minimum bending diameter (mm) | 4000 | ||
| Minimum cross section (mm) | 85×6 | ||
| Minimum bending diameter (mm) | 1600 | ||
| Outward bending of channel steel | Channel steel model | 50 | |
| Minimum bending diameter (mm) | 2400 | ||
| Inward bending of channel steel | Channel steel model | 50 | |
| Minimum bending radius (mm) | 2400 | ||
| Plane bending of flat steel | Maximum cross section (mm) | 500×76 | |
| Minimum bending diameter (mm) | 2400 | ||
| Vertical bending of flat steel | Maximum cross section (mm) | 200×60 | |
| Minimum bending diameter (mm) | 2500 | ||
| Bending of round pipe | Maximum cross section (mm) | 323×10 | |
| Minimum bending diameter (mm) | 4200 | ||
| Bending of round bar | Maximum cross section (mm) | 160 | |
| Minimum bending diameter (mm) | 2000 | ||
| Bending of square pipe | Maximum cross section (mm) | 200×12 | |
| Minimum bending diameter (mm) | 5000 | ||
